Maintenance & Storage; Locking Power Cord; Wireless Safety - Midtronics DCA-8000 User Manual

DCA-8000
8.5 When disconnecting the charger, always do so in the reverse sequence of the connecting procedure;
break the first connection while staying as far away from the battery as practical.
9 Maintenance & Storage
Follow these guidelines to protect the charger and test cables from damage and premature wear:
9.1 The grease, dirt, and sulfation that build up on battery terminals are highly corrosive and can
damage the clamps over time. Before connecting the clamps, ensure accurate test readings
and protect the clamps by cleaning the battery case and terminals using a wire brush and a
mixture of water and baking soda.
9.2 Periodically clean the clamps using a mixture of baking soda and water, or a mild hand-soap, and
a small bristle brush.
9.3 Clean the battery terminals. If stud adapters are required, fasten them with the proper tool. Do
not use the battery clamps to tighten adapters.
9.4 Never remove the clamps from a battery to abort an active charging session. Always press the
red STOP button before removing the clamps.
9.5 Do not leave the clamps laying in battery acid.

Locking Power Cord

Always pull back on the red tab on the side of the power cord connector to release/remove it from
the charger's power socket.
Storage
Always store the charger in safe, dry location and maintain it in perfect condition.

10 Wireless Safety

The operation of this equipment is subject to the following two conditions.
1. This equipment or device may not cause harmful interference.
2. This equipment or device must accept any interference. Including interference that may
cause undesired operation.
www.midtronics.com
SAVE THESE INSTRUCTIONS
Release
General Safety Precautions
11