Midtronics DCA-8000PM Quick Manual

IMPORTANT: Always leave the DCA-8000 plugged-
in when not in use to allow the tool to automatically
check for and perform any available software updates.
Charging Cables
1. Insert the communication cable
until the connector locks into
place.
2. For strain relief, pre-twist each
quick connector counter clock-
wise, before inserting and rotat-
ing clockwise 180° onto each
Locking Post on the back of the
charger.
3. The connection process is complete when all three cables
are secured to the charger.
Locking Power Cord
1. Install power cord.
2. If removal is necessary, pull back
on the red tab on the side of the
connector to release/remove the
power cord from the charger's
power socket.
Wireless Barcode Scanner Cable
1. Insert the RJ50 connector into the bottom of the scanner
base until it clicks into place.
2. If necessary, using a flat blade screwdriver, pry off the
plastic cover over the DB9 connection on the back of the
charger.
3. Use the thumb screws on the DB9 connector to secure the
cable from the dock to the charger.
NOTE: The barcode scanner base is magnetic and can
be placed anywhere on top of the DCA charger.
DCA-8000PM
Initial Setup
1.
Pull back to release
2.
Upon initial power-up, the Language Settings screen is dis-
played. If necessary, adjust the language settings for your
dealership, then tap Next to continue.
System Select the Controller default language
Language displayed on the screen.
Test Result Select the Controller default language for
Language all displayed tests and test results.
Email Select the default standard language for
the analyzer to use for all tests and results
Language
sent via email.
Print Select the default standard language for
Language the analyzer to use for all tests and results
printed using a networked printer.
A Consent To Collect Data screen is displayed. Read the
terms for collecting data, tap the Consent check box and
then tap Next to continue.
Page
1
Quick Reference Guide
Oct. 2020
167-000985EN-B