Symbols And Warnings; Operator Liability; Personnel Qualification; Transport Safety Information - ABB FSM4000 Series Commissioning Instruction

Safety
1.6

Symbols and warnings

Danger – <Serious damage to health / risk to life>
One of these symbols in conjunction with the "Danger" warning indicates an imminent danger.
If it is not avoided, death or serious injury will result.
Warning – <Bodily injury>
The symbol in conjunction with the "Warning" message indicates a possibly dangerous
situation. If it is not avoided, death or serious injury could result.
Caution – <Slight injuries>
The symbol in conjunction with the "Caution" message indicates a possibly dangerous
situation. If it is not avoided, slight or minor injury can result. May also be used for property
damage warnings.
Notice – <Property damage>
The symbol indicates a possibly damaging situation. If it is not avoided, the product or
something in its area can be damaged.
Important
The symbol indicates operator tips or especially useful information. This is not a message for a
dangerous or damaging situation.
1.7

Operator liability

Before the use of corrosive and abrasive measuring fluid, the operator must clarify the
resistance of all parts that come into contact with the fluid to be measured. ABB will gladly
support you with the selection, however, cannot accept any liability.
The operators must strictly observe the applicable national regulations in their countries with
regards to installation, function tests, repairs, and maintenance of electrical devices.
1.8

Personnel qualification

The installation, commissioning and maintenance of the device may only be carried out through
trained specialist personell authorized by the plant operator. The specialist personnel must have
read and understood the manual and comply with its instructions.
1.9

Transport safety information

Observe the following information:
• Depending on the device, the center of gravity may not be in the center of the equipment.
• The protective plates or dust caps mounted at the process connections of devices equipped
with PTFE/PFA may only be removed before installation.
To prevent possible leakage, make sure that the liner on the flange is not cut or damaged.
6 - EN FSM4000 D184B141U02