Advertisement
You can connect an external switch to clear CMOS. This switch
closes JP9 and turns off the power, at which time the CMOS
setup can be cleared.
*default
You can set the JP10 to protect BIOS write-enable. The configu-
ration is as follows:
*default
This jumper sets the voltage supplied to the Flash BIOS Write-
enable. The figure below shows the proper jumper settings for
both 5 V and 12 V voltage.
*default
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
*
Protect
Write protect*
5 V *
1
3
Clear CMOS
Write-enable
12 V
1
3
Chapter 2 Installation
33
Advertisement
