Advertisement
You can connect an external switch to easily reset your comput-
er. This switch restarts your computer as if you had turned off
the power then turned it back on. The following table shows the
pin assignments for the CN1.
Pin
1
2
You can connect a LED indicator across CN2 to indicate when
the CPU is in Turbo mode. Marks on the circuit board indicate
LED polarity (the pin on the left is positive).
Pin
1
2
You can connect a switch across the pins of CN8 to change the
CPU speed between Turbo and non-Turbo mode. When you
leave the pins open, the CPU card operates at full speed. When
you close the pins, the card operates at slow speed for compati-
bility with older software.
Pin
1
2
*default
32 SBC-410 User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Function
Ground
Reset
Function
Turbo
Ground
Function
- Deturbo
Pull low
Low speed
High Speed
*
Advertisement
