Advertisement
You can attach up to four Enhanced Integrated Device Electronics
hard disk drives to the SBC-410's internal controllers. The card
comes with a 40-pin and a 44-pin flat-cable piggyback cables. The
40-pin flat-cable has three identical 40-pin connectors.
Wire number 1 on the cable is red or blue, and the other wires are
gray.
1. Connect one end of the cable to Primary IDE or Secondary
IDE on the CPU card. Make sure that the red (or blue) wire
corresponds to pin 1 on the connector, which is labeled on the
board (on the right side).
2. Plug the other end of the cable to the Enhanced IDE hard
drive, with pin 1 on the cable corresponding to pin 1 on the
hard drive. (See your hard drive's documentation for the
location of the connector.)
Unlike floppy drives, you can make the connections with any of
the connectors on the cable. If you install two drives, you will
need to set one as the master and one as the slave. You do this
using jumpers on the drives. If you install just one drive, set it as
the master.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 2 Installation
19
Advertisement
