Arbonia Sabiana Energy Smart Series Installation, Use And Maintenance Instructions page 28

English
Condensate drain connection
Position the condensate drain based on the desired
connection:
Unscrew the plug and fix a drain or siphon as
indicated in the figure.
Condensate must be drained from a minimum
height of 100 mm.
If you choose the version with right side connection,
swap the plug of the condensate drain.
standard
connection
Y
SETTING THE FLOW RATES
Before setting flowrates, fans are run at factory default
speed.
Before setting flowrates, Touch Pad is inithbited to
perform any speed modulation. This is communicated
by the message "Tab" blinking in the central field of
the display.
WARNING!: no speed regulation is possible without
first flowrate setting
DAY
28
Y
right
side connection
°C
To set the air flow rate based on the number of fan
revolutions, there are two possible types of calibration:
• STANDARD CALIBRATION
• AUTOMATIC CALIBRATION
only with Automatic Flow Rate Control sys-
tem installed
STANDARD CALIBRATION
– L S
eft ide
1. Use a screwdriver to remove the front panel cover.
2
3
2. Remove the rubber caps of the connections P1 and P2
relative to fan V1.
C –
onfiguration
1