Tank Housing - Stihl GS 461 Manual

1
: Use hook 5910 893 8800 to pull
the fuel suction hose (1) out of
the fuel tank
Take care not to overextend the fuel
suction hose.
– Fit the pickup body, b 10.8.1
– Close the filler cap
– Reassemble remaining parts in
reverse order

10.8.3 Tank housing

– Empty the fuel tank, b 1
– Remove the carburetor, b 10.3
– Remove the ignition module,
b 6.2
– Unscrew the ring buffer screws,
"Ring buffer fuel tank / clutch
side", b 8.1,
"Ring buffer fuel tank / ignition
side", b 8.1.1,
"Ring buffer guard / ignition side",
b 8.1.3, "Ring buffer guard /
clutch side", b 8.1.2
80
2
1
: Remove washer (1) and
sleeve (2)
1
2
: Press the manifold flange (1) out
of the tank housing (2) by hand in
the direction of the cylinder
1
– Pull tank housing out by approx.
30 mm
: Disconnect the impulse hose (1)
from the connector (arrow)
1 2
: Press out grommet (1) in the
direction of the cylinder and pull
out wiring harness (2) in the
direction of the cylinder
1
: Pull out the tank housing (1) and
examine it, replace if necessary
Those parts of the old tank housing
which are not supplied with the new
tank housing must be reused – see
spare parts list.
– Reconfigure the front handle,
b 8.2
– Reconfigure the switch shaft,
b 9.1
– Reconfigure the front handle,
b 6.6
– Reconfigure the interlock lever
and throttle trigger, b 9.2
GS 461