Bar Mounting Studs; Collar Nuts For Chain; Sprocket Cover - Stihl GS 461 Manual

4.6

Bar mounting studs

– Remove outer side plate,
b 8.1.2
– Unscrew studs out of the
crankcase using stud driver
5910 893 0501
1 1
: When fitting, coat thread (1) of
the studs with Loctite, b 12
: Screw in and tighten studs (1)
with stud driver (2)
5910 890 3000
GS 461
– Reassemble remaining parts in
reverse order
4.7

Collar nuts for chain

sprocket cover

To replace the nuts, use special tool
stud 5910 893 9601.
2
– Remove chain sprocket cover
: Screw the assembly tool (1)
5910 893 9601 with the stud
marking "S" as far as it will go into
the collar nuts (2)
– Flip over the chain sprocket cover
and clamp the assembly tool into
a vise by the hexagon
: Drill out the collar nuts with an 11
mm diameter drill bit – the base in
the chain sprocket cover must not
be drilled out
– Pull out the collar nuts
– Unscrew the assembly tool from
Installation
2 1
: Push in new collar nuts (1)
2
– Hold the hexagon of the collar
: Screw the assembly tool (1)
Now the new collar nuts have been
flanged and secured in the chain
sprocket cover to prevent loss.
– Reassemble remaining parts in
the collar nuts
1
nuts in place
5910 893 9601 with the stud
marking "L" into the opposite side
of the collar nuts as far as it will
go
reverse order
1
1
21