Stihl GS 461 Manual page 57

2 1
– Use STIHL press fluid to simplify
assembly, b 12
: Push the ring (1) onto the
sleeve (2) as far as it will go
1
– Fit tank housing on ring buffer –
the holes must line up
: Push sleeve (1) with ring into the
ring buffer, screw in screw (2)
and tighten
– Reassemble remaining parts in
reverse order
56
8.1.2 Ring buffer guard / clutch
side
: Unscrew screw (1) and remove
side plate (2)
2
1
: Pry out plug (1)
1
: Remove screw (1) and prise out
ring buffer (2)
– Examine the ring buffer, replace if
necessary
1
1
2
: Remove rubber ring (1) from stop
– Check rubber ring, replace if
Installation
1
– Use STIHL press fluid to simplify
: Push rubber ring (1) through the
2
Rubber ring must not become
jammed between the ring buffer and
tank housing.
dome of the tank housing and
push through the hole (arrow) of
the crankcase
necessary
assembly, b 12
hole (arrow) of the crankcase and
press as far as it will go onto the
stop dome of the tank housing
GS 461