Throttle Trigger; Trigger Interlock - Stihl GS 461 Manual

2
1
: Position screwdriver at the tab (1)
and press switch shaft (2) into the
guide (arrow) until it engages
: Short-circuit wire (1) and ground
wire (2) must be between the fin
(arrow) and housing wall, push in
completely if necessary
– Short-circuit wire (1) must be
routed below the ground wire (2)
: Check correct functioning
– The eyelet (1) of the short-
circuit wire must touch the
contact spring (arrow) in position
"0"
– Reassemble remaining parts in
reverse order
64
9.2 Throttle trigger / trigger
interlock
– Remove air filter, b 10.1
– Open the throttle wide and hold,
then unhook throttle rod from

throttle trigger

1
2
2
: Unscrew screw (2) and remove
handle molding (1)
– The trigger interlock (arrow)
may pop out.
1
: Pull trigger interlock (1) out of the
bearing points (arrows)
3
1
: Drive pin (1) out with punch (2)
and remove throttle trigger (3)
with torsion spring
– Examine trigger interlock, throttle
1
trigger and torsion spring,
replace if necessary
Installation
1
1
: Hook the torsion spring (1) into
the throttle trigger (2)
– Note the installed position
(arrow)
2
2
GS 461