Stihl GS 461 Manual page 82

Installation
1
: Push rubber ring (1) with inside
diameter 12 mm and rubber
ring (2) with inside
diameter 18 mm onto the stop
domes (arrows)
1
2
: Push tank housing (1) with the
narrow part (2) first between the
crankcase halves as far as it will
go onto the intake elbow
GS 461
1 2
2
Grommet (1) must be pushed on.
– Use STIHL press fluid to simplify
assembly, b 12
: Push wiring harness (2) through
the opening and press
grommet (1) into the opening
until it encloses the opening on
both sides
: Pull wiring harness (2) in until the
start of the protective tube is at
the fin (arrow)
2
: To pull in the manifold flange (1),
place a string (2) that is approx.
15 cm long around the manifold
flange and feed through the hole
in the tank housing
: Align impulse hose (1) so that the
flange with the rounded side
(arrow) faces upward
2
– Push tank housing towards the
cylinder and hold in place
: Pull the manifold flange (1)
through the hole with the ends of
the string (2)
– Remove the string
1
1
1
81