Canon LV-WU360 User Manual page 90

Network control
• The above-mentioned control may not be performed correctly or the monitoring data may not
be obtained correctly in the following conditions:
• During standby
• During input source switching
• During command processing
• During AUTO PC execution
• Before the splash screen disappears after the power is turned on.
• Use 1 computer to control/monitor 1 projector.
• For how to control/monitor using PJLink™, see the operation manual of the PJLink™application you
use.
• When you monitor the projector's operating state using this function by issuing inquiry commands
successively, issue an inquiry command after receiving the response to the previous inquiry
command from the projector.
Using the Network Function when the projector is in standby mode
When the Standby LAN in the SYSTEM SETUP: Advanced > LAN Settings menu is activated, the
projector is able to provide the network function when it is in standby mode.
Glossary
For more detail of the glossary below, refer to the technical book that is commercially available.
Term
DHCP
IP Address
Subnet Mask
Default
Gateway
Description
Abbreviation for Dynamic Host Configuration Protocol. This protocol
automatically assigns IP Address to networked devices.
Numerical address to identify networked computers.
A numeric value to define the number of bits used for a network
address of a divided network (or subnet) in an IP Address.
A server (or router) to communicate across networks (subnets) that are
divided by Subnet Mask.
90