Use:
Use ICC (Immersion Circulator Compact) control for heat-
ing and circulating fluids.
Intended Use: Tabletop Device
Range of use (indoor use only):
- Laboratories
- Schools
- Pharmacies
- Universities
Unpacking:
- Please unpack the device carefully
- In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder).
Transport safety:
NOTICE
Remove the transport protection
under the
Setting up:
- Securely fix the immersion circulator on the bath.
- Place the device on an even, stable, clean, nonslip, dry
and fireproof surface.
- Keep at least 20 cm of open space at the front and rear
side.
- When a plastic bath is used, please ensure that the heater
does not contact the bath.
- The place for installation should be large enough and
provide sufficient air ventilation to ensure the room does
not warm up excessively because of the heat from de-
vice radiates to the environment.
- Do not set up the device in the immediate vicinity of
heat sources and do not expose to sun light.
Correct use
Unpacking
(4).
buoyage
Preparations
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply
network that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not
supplied or recommended by the IKA
- If the device is operated improperly or in contrary to the
®
specifications.
IKA
- If the device or the printed circuit board are modified by
third parties.
Delivery scope:
- ICC control
- Mains cables
- Screwdriver (use for safety circuit)
- USB 2.0 cabel A – micro B
- User guide
- A warranty card.
Filling and draining:
- Connect the mains plug and turn on the device with
mains switch (2).
- The low level icon ( ) appears on the display.
- Fill fluid to the bath.
Note: Pay attention to the fluid level information on
the display:
— Low level
— High level
For draining, please refer to the bath operating instruc-
tions.
®.
7
Need help?
Do you have a question about the ICC control and is the answer not in the manual?
Questions and answers