Related Manuals for Biosan PSU-10i
Summary of Contents for Biosan PSU-10i
- Page 1 Medical–Biological Research & Technologies PSU-10i Orbital Shaker Operating Manual for version V.3AW Certificate...
- Page 2 Page 2...
-
Page 3: Table Of Contents
Contents Safety Precautions General Information Getting Started Operation Specifications Maintenance Warranty and Claims Declaration of Conformity Page 3... -
Page 4: Safety Precautions
Safety precautions The following symbols mean: Caution! Make sure you have fully read and understood the present Manual before using the equipment. Please pay special attention to sections marked by this symbol. GENERAL SAFETY Use only as specified in the operating instructions provided. ·... -
Page 5: General Information
The two-line LCD display shows both actual and set parameter values These very quiet and reliable shakers can provide stable continuous mixing up to 168 hours. PSU-10i with its wide speed range, load up to 3 kg and extensive choice of platforms is applicable in different laboratories: BIOTECHNOLOGY... -
Page 6: Getting Started
It is a normal occurrence and does not indicate a fault or a loose part. 3.2. Complete set. Package contents: Standard set PSU-10i Orbital Shaker ................1 piece External power supply unit ..............1 piece Operating Manual; Certificate..............1 copy... - Page 7 3.3. Set up: place the unit on the horizontal even working surface; remove protective film from the display; plug the external power supply unit into the 12 V socket at the rear side of the unit. 3.4. Install the platform to the movable base by inserting the pins on the underside of the platform into the holes on the supporting platform on the movable base.
-
Page 8: Operation
Operation 4.1. Connect the external power supply unit to electric circuit. 4.2. Place samples on the unit platform. 4.3. Set the required working time interval in hours and minutes (the increment is 1 min) using the p and q Time keys (Fig. 1/1). Pressing the key for more than 2 s will increase the increment. -
Page 9: Specifications
Spring holder for 88 10 to 50 ml tubes BS-010116-BK HB-200 Additional holding bar for UP-12 BS-010108-FK Biosan is committed to a continuous programme of improvement and reserves the right to alter design and specifications of the equipment without additional notice. Page 9... -
Page 10: Maintenance
7.3. If any manufacturing defects are discovered by the Customer, an unsatisfactory equipment claim shall be compiled, certified and sent to the local distributor address. Please visit www.biosan.lv, Technical support section to obtain the claim form. 7.4. The following information will be required in the event that warranty or post- warranty service comes necessary. -
Page 11: Declaration Of Conformity
Declaration of Conformity Version 3.05 - April 2014...
Need help?
Do you have a question about the PSU-10i and is the answer not in the manual?
Questions and answers