Horizon Fitness GR6 Service Manual page 8

DAILY

Wipe down the indoor cycle after each use to remove sweat and moisture. Use soap and
water, or a diluted non-abrasive domestic cleaner solution. Rinse to remove detergent
residue and then dry off.

Before each session, inspect for loose components such as pedals or cranks prior to
commencing the next use. Tighten up any loose parts.
WEEKLY

Check for proper flywheel alignment. Torque flywheel nuts as necessary.

Remove chain guard and check for loose chain. Adjust and lubricate the chain as
necessary.

Check to make sure the crank arms are tight to the bottom bracket.

Inspect all parts, nuts, bolts, or screws for adjustments, replacements or maintenance.
MONTHLY

Inspect the frame and main assembly components for rust or corrosion. Tilt the cycle or
place in an upside down position to locate areas where rust and corrosion may develop.
Use a small, wire brush to remove rust build-up in small crevasses, such as leveling feet,
quick release levers and other bolt assemblies.

Inspect all wear items for adjustments or possible part replacement. Give particular
attention to the following:
a. Inspect brake pad for wear. Excessive wear or dryness indicates replacement is
required.
b. Inspect seat pad for wear. Rips, tears or excessive movement indicates
replacement is required.
c. Inspect pedals for play. Excessive movement of pedals indicates replacement is
required.

Inspect the chain for tensioning by rotating the crank to drive the flywheel forward. Do
this motion in 1/4 turns to assess if there is free play between the crank and the flywheel.

Dryness or prolonged use may cause the height and reach adjustments for the seat and
handlebar to become tight. If this is the case, the sliding assembly should be removed
from the frame and have a smear of light duty grease applied along the sliding surface
before assembly. Similarly, apply some light grease to the clamping assembly to ensure it
does not seize up. Clean off excessive grease before reassembly.

Please lubricate the seat post, brake pad and handlebar adjustment regularly with
lubricant in your parts package.
8