dehn DEHNrecord DRC MCM XT Quick Start Manual page 25

Quick Start Guide DEHNrecord DRC MCM XT
Continued from 5.3
to
page 8
Note:
A module can only be reset to its initial condition via the DRC LC M3+ test device or the DRC MCM XT
and the "Status Display + Service Console" software! Already programmed modules cannot be reset via the
DRC MCM!
page 9
Attach number label
for programmed password
(bus/MCM adress • position number)!
click
yes alle SPD's
Further SPDs to
programmiert
be programmed?
?
no
Automatic status determination
at the end of the programming process.
Monitoring status
In case of multiple application one
DRC MCM has to be switched into the
Master
Master mode to start monitoring!
Slave