Programming Via Pc Using The "Status Display And Service Concole" Software - dehn DEHNrecord DRC MCM XT Quick Start Manual

Quick Start Guide DEHNrecord DRC MCM XT
5.2 Programming via PC using the "Status Display and Service Console" software
Initial condition during start-up
Insert
next SPD
from the outside
to the inside!
Results
display
Progress
bar
Hints
continued from page 7
Start Service Console at the
DRC MCM XT Status Display
Service functions System description
start Service Console
min. 2 sec.
Start Service mode at the
DRC MCM XT
Always insert
only one unprogrammed
SPD for programming! stecken!
Do not insert it completely!
see figures
Busaddress
of the
DRC MCM XT
Select
command
After selecting the bus address of the DRC MCM XT and
indication of a positive result:
1. Select command
"Program individual SPD for DRC MCM XT"
2. Select SPD
"SPD <No.>"
3. Send command
Observe progress bar and hints, wait until the result
is displayed.
see page 7
Faulty SPD is removed for maintenance
Observe hints!
SPD
No.
Quit
Service
Console!
page 6