Support; Safety Instructions; Disposal - dehn DEHNrecord DRC MCM XT Quick Start Manual

Quick Start Guide DEHNrecord DRC MCM XT

11. Support

Additional information and notes:
- Detailed operating manual, Publication No. 1669
- DRC MCM XT software
- "Status Display + Service Console" software
can be downloaded from www.dehn.de/download/, Measuring and Test Systems,
or can be ordered as CD-ROM version for a fee!
After login / registration (for new customers)
- the individual data (readme, device software, operating manual, PC software)
- the CD with the complete documentation and software
can be donwloaded from the "DEHNrecord - DRC MCM XT" directory or
- the CD can be ordered by mail.

12. Safety instructions

IEC 60417-6182:
Installation,
electrotechnical expertise
Only licensed electricians are allowed to connect and install the DRC MCM XT test device. National provisions and safety
regulations have to be observed.
The test device has to be checked for external damage before installation. If damage or any other defect is detected, the
test device must not be installed.
The test device may only be used according to the conditions specified and shown in the installation instructions.
If loads exceed the specified values, the test device and the electrical equipment connected to it may be damaged.
Tampering with or modifications to the test device invalidate the warranty.

13. Disposal

The device should not be disposed of in the normal household waste.
For more Information please refer to our website:
www.dehn-international.com
Note:
Furthermore, DEHN + SÖHNE GmbH + Co.KG. assumes no reliability for any damage caused by computer programs and warns of viruses and data losses
that may arise due to programming errors. This can be avoided by performing a data backup. The information provided in the present document may be
modified without prior notice. DEHN + SÖHNE GmbH + Co.KG. cannot be held liable for any modifications.
page 15