Programming Via The Drc Mcm Xt Monitoring Device (Show Sub-Function) - dehn DEHNrecord DRC MCM XT Quick Start Manual

Quick Start Guide DEHNrecord DRC MCM XT

5.3 Programming via the DRC MCM XT monitoring device (SHOW sub-function)

DRC MCM XT for programming the SPD
is Master device remains in Master mode!
is Slave Master device at the bus has to be switched into the Slave mode!
Initial condition during start-up
continued from page 9
DRC MCM XT
Start SHOW funktion at the
Indication of the SPD No. (= number of red flashlights)
e.g. SPD No. 2 corresponds to the number of the SPD to be programmed
(repeat for 1 minute).
Push the Service button to switch to the
programming mode until the LED
indication flashes orange
only one unprogrammed
SPD for programming!
Do not insert it completely!
5 sec.
or
5 sec.
Faulty SPD is removed for maintenance
min. 2 sec.
DRC MCM XT
Always insert
See figures
Start programming by means of pushing the service button
until the LED indication flashes permanently
orange.
Programming in progress, wait until the process is completed!
Programming failed, repeat
Programming successful
to page 9
device software
≥ version 1.008
page 8