Manual Abort Of A Running Spd Fest; Confirmation Of The Remote Signalling Contact (Show Sub-Function) - dehn DEHNrecord DRC MCM XT Quick Start Manual

Quick Start Guide DEHNrecord DRC MCM XT
8. Manual abort of a running SPD test
SPD test running
Abort of the
SPD test
Indication of
the
last valid status
9. Confirmation of the remote signalling contact (SHOW sub-function)
Start of the
indication sequence
LED indication
First SPD to be replaced
Sync
button
Resetting the remote
signalling contact
and the status indicator
The status display changes after confirmation:
• if another predamaged SPD is detected:
"Replace SPD" monitoring status"
• if all predamaged SPDs were replaced:
"All SPDs OK" monitoring status"
page 13
Master
or
Slave
Master
LED
LED
LED
or
Slave 1-n'
Slave 1
Slave 1 Slave 1
LED
LED
LED
oder
LED
Master
Slave
Quantity = SPD No. of the protective device to be replaced (e.g. No. 3)
• Press any key
(show, sync or service)
• Release button as soon as LED goes out
Press key
Remote signalling
contact
13 14 21 22
21 22
13 14
21 22
13 14
Remote signalling
contact
FM-Kontakt
13 14 21 22
21 22 21 22
13 14
13 14
21 22
13 14
13 14 21 22
LED
Press show and keep button depressed until the indication sequence starts!
button
Keep sync button depressed until the
indication changes to green.
button
Master
LED
Slave
LED
Master
LED
Slave LED
Master LED
Slave LED
device software
≥ version 1.008
Last valid status
or
2 sec.
or
device software
Remote signalling
≥ version 1.008
contact
21 22
13 14
ca. 5 sec.
Remote signalling
contact
21 22
13 14
Remote signalling
contact
13 14 21 22
Remote signalling
contact
21 22
13 14