Samsung AM JXVHGH Series Installation Manual page 89

Insulate the refrigerant pipe
f Make sure to insulate the refrigerant pipe, branch joint, distribution header, and the connection part of the pipes . X
f If you insulate the pipes, condensed water will not fall from the pipes .
X
f Check if there are any cracks on the insulation at the bent part of the pipe .
X
Insulator
Gas side
pipe
Liquid side pipe
Insulating pipes
• The insulation of the gas and liquid pipes can be in contact
with each other but they should not press excessively
against each other .
• When the gas side and liquid side pipes are contacting
each other, increase the thickness of the insulation by one
grade .
Insulator
Gas pipe
• Install the insulation without any gaps or cracks and
use adhesive on the connection part of it to prevent
CAUTION
moisture from entering .
• Bind the refrigerant pipe with insulation tape if it
is exposed to outside sunlight . (When binding the
pipe with finishing tape, be careful not to reduce
the thickness of the insulation .)
• Install the refrigerant pipe respecting that the
insulation does not get thinner on the bent part or
hanger of pipe .
• When the thickness of insulation is reduced,
reinforce the reduced thickness with additional
insulation .
DVM S HE_IM_DB68-05461A-08_EN.indd 89
Clamp
Indoor unit
Insulator
Insulating pipes connected behind the EEV kit
• When installing the gas side and liquid side pipes, leave at
least 10mm of space .
• When the gas side and liquid side pipes are contacting
each other, increase the thickness of the insulation by one
grade .
Insulator
Liquid pipe
Additional Insulator
Insulator
Install the insulation to be
overlapped
Fix securely without any gap .
10 mm 10 mm 10 mm
Gas pipe
Hanger
a
a x 3
Liquid pipe
Insulator for
refrigerant pipe
89
2017-03-24 오후 1:38:42