Installing And Removing The Belt Clip - Tait Orca Manual

For information on charging and conditioning the battery,
see pages 47 to 50.
To fit the battery pack to the radio, insert the bottom edge
of the battery pack into the two slots at the back of the
radio. Push the battery pack towards the radio. It should
snap into place.
To remove the pack, push the battery catch down and from
the sides, pull the battery away from the radio.

Installing and removing the belt clip

Slide the belt clip into the two slots on the top of the
battery. Push down until the clip snaps into place.
Belt clip
Slots
Battery
The belt clip has been designed to avoid accidental removal.
However, it can be replaced if required.
To remove the belt clip, insert the end of a flat-bladed object
(e.g. a butter knife) under the edge of the release tab
without forcing it. Gently lift the release tab up, then slide
the belt clip away from the battery.
Should the small battery clip come loose while removing the
belt clip, it can easily be refitted by sliding it into the slot at
the top of the battery until it snaps into place.
Battery clip
Release
tab
7 7 7 7 7