Device Settings - Drager X-am 5000 Technical Manual

Device settings

Only trained personnel are permitted to make changes to the device configuration.
The following changes can be made to the device parameters for a device:
Designation
Password
Operating signal LED
Operating signal horn
Switch-off mode
2)
Shift length (TWA)
Short-term exposure limit (STEL)
minutes)
User ID(12 characters)
Switch database on or off
Overwrite database
Database mode
Database interval
Date
Time
Warning after expiry of calibration interval Yes/No
Error after expiry of calibration interval
Delay until error after expiry of calibration
interval (days)
Automatic detection of Bump Test Station Yes/No
Activate sensitivity calibration following
negative bump test
Bump test mode
Warning after expiry of bump test interval Yes/No
Error after expiry of bump test interval (if
warning activated)
Capture range
Remote configuration
Bump test interval (days)
NOTICE
1)
1)
(in minutes)
3) 4)
(in
Configuring the Device
Field
Numeric field (3-figure)
Yes/No
Yes/No
"Switch off permitted" or
"Switch off prohibited" or
"Switch off prohibited at A2"
60 - 14400
(setting for exposure alarm)
0 - 15
(setting for exposure alarm)
Alphanumeric field
On/Off
Yes/No
Peak/Average
1 s / 10 s / 30 s / 1 min / 2 min / 5 min /
10 min / 30 min
(date on the PC)
(time on the PC)
Yes/No
0 - 10
Yes/No (relates only to a device
connected to the Dräger Bump Test
Station)
"extended bump test" or "quick bump test"
or "bump test deactivated"
Yes/No
Yes / No
Yes / No
1 - 732
27