Quantum StorNext QD6000 Replacing Manual page 10

Press down on both of the top cover latch buttons as you slide the top cover off the controller canister.
Figure 6. Battery and Locking Tab in the Controller
1. Top Cover Latch Buttons
2. Battery Circuit Board
3. Battery Locking Tab
3. Remove the failed battery.
a. Move the battery locking tab down to pull the failed controller battery out of the controller canister.
b. Remove the failed controller battery by sliding it towards the rear of the controller canister.
4. Install the new battery.
a. Insert the new battery at a slight downward angle into the controller canister.
b. Slide the battery towards the front of the controller canister making sure that the battery slides under the side
guide pins as you continue to slide the battery to correctly seat it against the back surface.
If the battery is not correctly seated, you will not be able to reinstall the top cover on the controller canister as
directed later. If you suspect that the new battery is not correctly seated, you might need to slide the new battery
out and insert it again.
5. Move the locking tab up to secure the new battery circuit board to the controller canister.
6. Reinstall the top cover on the controller canister by sliding it forward until the top cover latch buttons click.
Reinstalling the Controller Canister
1. Remove the controller air blocker.
6 - Replacing a Battery in the E5660