Quantum StorNext QD6000 Replacing Manual page 8

b. Push the drive handle to the right (E5612 controller-drive tray) or down (E5624 controller-drive tray) to lock
the drive securely in place.
Figure 4. Installing a Drive in the E5612 Controller-Drive Tray
1. Drive Handle
Figure 5. Installing a Drive in the E5624 Controller-Drive Tray
1. Drive Handle
NOTE Depending on your configuration, the controller might automatically reconstruct data to the new drive. If
the controller-drive tray uses hot spares, the controller might need to perform a complete reconstruction on the
hot spare before the controller copies the data to the replaced drive. This reconstruction process increases the
time that is required to complete this procedure.
2. Check the Drive Power LED and the Drive Service Action Required LED (LEDs on the Drive Drawer -- Front
View). Based upon the LED status, perform one of these actions:
The Drive Power LED is on, or the Drive Service Action Required LED is off – Go to step 5.
The Drive Power LED is off – The drive might not be installed correctly. Remove the drive, wait 30 seconds,
and then reinstall it. Go to step 3.
4 - Replacing a Failed Drive in the E5612 or the E5624 Controller-Drive Tray