Table of Contents
Advertisement
Section 2
Quick Start Guide For Pi Images
(for those of you who don't like to read directions)
1. Use
DreamUp
to the null modem cable but unplug the power. (I no
longer recommend using your ethernet cable. There are
too many problems using DreamUp with the ethernet
cable.) Click the 'Erase' button and erase the old image
from your box before installing any new image. Choose
the Pi image or any image of your choice and click 'Flash'.
This procedure takes a long time. (I always flash with the
latest 'Official Image' from
tv.de/Bereiche/Produkte/downloadscenter.php
up before flashing with a private image but not everyone
does.)
2.
Configure
the 'Expert Settings' section.
3. Use
DreamBoxEdit
List (channel list) from our forum. Anytime you scan
transponders you erase info in the service list. Dish
Network transponders cannot be scanned so don't try. If
the desired satellites are in the service list on this forum
use it. If you need to add satellites, scan them in one at a
time using automatic scan.
4. Setup
'Satellite
5. Reload service list with DreamBoxEdit. Repeat this step
anytime you make changes in 'Satellite Configuration'.
6. Reboot if you plan to tune FTA only, otherwise proceed to
step 7.
to flash your image. Connect your DM500
your connection settings in "Communications" in
to load the most recent DBNA Service
Configuration'.
http://www.dream-multimedia-
and boot
Advertisement
Table of Contents
