Table of Contents
Advertisement
button or the down arrow button to the "Store" box
and store this position.
29. On the screen that comes up enter "1" in the
"Storage Location" box and press the
or the down arrow button to the "Save" box and save
the changes you have just made.
30. Browse down to "Mode" and select "recalculate" from
the drop-down menu.
31. Press the
the "recalculate" box and save the changes you have
just made.
32. It will then ask "Are you sure?" Press the
button or the down arrow button to the "Yes" box to
save.
33. Press the
the "prev page" box.
34. Browse down to "Number in Motor" and enter "2".
35. Browse down to "Orbital Position" and enter "910" for
91W satellite.
36. Browse down to "Direction" and select "West" from
the drop-down menu.
37. Press
the "add" box.
38. Repeat this procedure until all of your circularly
polarized satellites are entered. In this example that
would be: 82, 91, 110, 119, and 148.
39. Press the "Exit" button and then select "Motor
Setup".
40. You get a message that says you have more than one
LNB. Press "OK".
41. Select "LNB 1".
42. Start over with "Step 32" above to enter the linearly
polarized satellites. In this example that would be:
97, 105, and 121.
43. You will now need to scan any satellites that are not
listed in your DBNA service list.
Section
Section 10
Using FlashWizard for Backups
Green
button or the down arrow button to
Yellow
button or the down arrow button to
Yellow
button to or the down arrow button to
Green
button
Green
Advertisement
Table of Contents
