Warranty Information; Repair Service - Bio Compression Systems SC-3008 Operating Instructions Manual

OVERRIDING PRE-SET GRADIENT PRESSURES
1. A small screw driver is the only tool needed to adjust the gradient pressures.
2. If you turn the pump on its side, you will notice underneath, three screw ports labeled #3&4, #5&6 and
#7&8, each having a directional arrow indicating the way in which the pressure is increased.
3. It only takes a very small turn of the screw to adjust as you are adjusting (mmHg) as reflected on the
gauge.
4. With the pump on its side and while running, observe the gauge needle to set the desired pressure.

WARRANTY INFORMATION

You can feel confident that your product is backed by the best warranty in the industry covering any and all
malfunctions (including parts and labor) resulting from component and/or manufacturing defects.
Compression Pump = 3 years from date of purchase / invoice
Sleeves/Garments = 1 year from date of purchase / invoice
NOTES:_____________________________________________
Serial Number:_______________________________________
Date Purchased:______________________________________
Local Representative/Dealer:___________________________
Phone Number:______________________________________

REPAIR SERVICE

1-800-888-0908
BIO COMPRESSION SYSTEMS, INC.
120 West Commercial Ave., Moonachie, NJ 07074
www.biocompression.com
11