Advertisement
Checking the reference position
1.
Pull the crown out to position 1 .
2.
Rotate the crown to move the mode hand to point [CHR].
3.
Pull the crown out to position 2 .
The hands and indication move to the current reference positions stored in
memory and stop.
4.
Check the reference position.
Correct reference positions:
• Hour, minute and second hands: 0 hour
00 minute 0 second
• 24-hour hand: "24"
• Date indication: midway between "31"
and "1"
• Function indication "30" (straight
below)
When the current reference position is
different from the correct one, proceed to step 3 of "Correcting the reference
position".
5.
Push the crown in to position 0 .
6.
Change the mode to [TME] to finish the procedure.
Correcting the reference position
1.
Pull the crown out to position 1 .
2.
Rotate the crown to move the mode hand to point [CHR].
3.
Pull the crown out to position 2 .
4.
Press and release the lower right button A .
The function hands move slightly.
5.
Press and release the lower right button A repeatedly to
change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows:
Function hand/date indication → Hour/minute/24-hour hands → Second
hand → (back to the top)
• The hands slightly move when selected to show they become adjustable.
• The function hand points "60" (straight above) when the hour, minute,
second and 24-hour hands are the targets of adjustment.
6.
Rotate the crown to adjust the hand/indication.
• The hour, minute and 24-hour hands move synchronously.
• Date indication changes to the next as the function hand rotates 5 times.
• When you rotate the crown quickly a few times, the hand/indication will
move continuously. To stop the rapid movement, rotate the crown in either
direction.
7.
Repeat steps 5 and 6.
8.
Push the crown in to position 0 .
9.
Change the mode to [TME] to finish the procedure.
Resetting the watch — All Reset
1.
2.
3.
• Proceed to the next step when the hands and indication stop.
RX
LON
4.
ON
OFF
SMT
TME
ALM
TME
AKL
After All Reset
After All Reset, adjust the reference position, set the time and calendar and
execute alarm setting.
Pull the crown out to position 1 .
Rotate the crown to move the mode hand to point [CHR].
Pull the crown out to position 2 .
The hands and indication move to the current reference positions stored in
memory.
Press and release both the lower right button A and upper
right button B at the same time.
As you release the buttons, the alarm sounds and all reset is executed.
The setting values after All Reset
Time/calendar
January 1, Sunday of leap year
World time
LON
Summer time
SMT OFF at all time zones
Alarm setting
ALM OFF
Alarm time
0:00 AM
Reception result
NO
indication
E660 Abbreviated instruction
Advertisement
