Table of Contents
Advertisement
A. Lock washers (2)
rings (2)
B.
Container wall
Safety cable
C.
D.
Cable clips (4)
E. Air cannon tank
Fig. 6
© Martin Engineering GmbH
2. Route the safety cable (C) through the lock washer and make
a loop with an 80 mm diameter.
3. Install a cable clip (D) as closely to the loop as possible and an
additional cable clip at a distance of around 40 mm.
4. The free end of the safety cable, however, must be at least
25 mm in length.
5. Tighten the screws alternately and evenly to a defined torque,
see Table 2.
NOTE
Install the safety cable with a sag of 50 to 75 mm. Secure the ends
of any shortened ropes against protruding wires (risk of injury).
6. Repeat steps 2-5 on the air cannon tank.
26
B
E
A
C
D
M3727UK-09/15
Advertisement
Table of Contents
