Digital Outputs; Dip Switch - Eliwell 210 L Series Manual

Index Description
(dial Potentiometer input:
knob) Used to set the controller's operating set point, between
a minimum of 5 C° up to a maximum of 35 C°.
Related topics: Set point dial knob
Note: The presence of the water sensor is automatically detected by the controller during power start-up.
This means that functions
opening (only 2-pipe models) will be activated or not, depending on the presence of the water sensor.
The water sensor (analogue
possible to the battery. On a 4-pipe system, it must always be mounted on the hot water circuit, never on the cold water
circuit.
3.5

Digital outputs

Digital outputs consist of 3
Relays
Index Function
FAN Delivery
(refer to
OUT1 Valve
OUT2 Valve
3.6

Dip switch

The back of the electronic board (see photo) has 4 (or 6 in case of the universal models)
which are listed below:
and Range limitation
like temperature driven
inputs) should always be mounted on the water pipe, upstream of the
relays
fan control
Fan demand operation)
or electric heater control
control
use
-105° +105°
from average
point
Hot start, centralised On/Off (only 2-pipe models), periodic
Water sensor mounted upstream
Description
Starts ventilation. The fan control slider
used to set the phase on three different terminals
to permit manual selection of the 3 fan speeds.
If there is a battery of electric
pilots it; if not, it is used as a second
pipe installation.
Permits water to flow into the battery.
valve and as close as
can be
heaters, this relay
valve for a 4
dip switches, the functions
FC BASIC User Manual
valve
of
9/24