Fan Control Slider; Operating Mode Slider; Economy Slider (Optional); Led's - Eliwell 210 L Series Manual

4.2

Fan control slider

Switches the phase sectioned by the fan relay on three motor windings to achieve three different fan speeds:
High/Medium/Low.
Low speed:
4.3

Operating mode slider

Depending on the model (refer to table of models), it is possible to select Heating/off/Cooling operating mode or on/off
(0 / I) operating mode.
Heating mode: Cooling mode:
4.4

Economy slider (optional)

Located at the top of the controller and used to operate the
4.5

LED's

Three LED's are used to indicate the actual mode:
On/economy LED: (YELLOW)
Stays on during normal operation; Blinks during
Cooling LED: (GREEN)
Illuminates during cooling demand (cool) and in the Dead zone.
Blinking: indicates that regulation algorithm
start the fan.
Stays on: cooling is available(fan and
Heating LED: (RED)
Illuminates during heating demand (heat) and in the Dead zone.
Blinking: indicates that regulation algorithm
is not being given to start the fan. (refer to
Stays on: heating is available (fan,
All LED's Blink for 3 seconds when the controller is turned onto the power supply.
Alarm indication
All LED's continuously Blink to indicate an alarm status. An alarm will be generated if one of the sensors is damaged,
disconnected (some models mandatory need the water sensor), or short circuited, until the problem has been solved. This
will also appear when the window contact
Medium speed:
Off mode:
O
economy
has not been satisfied but consent, by the water sensor, is not being given to
valve active).
has not been satisfied but consent, by the water sensor (2-pipe models only),
Hot Start)
valve and/or electric heater are active)
has been activated (contact closed).
High speed:
On mode:
I
economy function.
operation
FC BASIC User Manual
12/24