Connection Diagrams; Out1; Out2; Analogue Inputs - Eliwell 210 L Series Manual

Is not directly affected by a heating or cooling source
!
Is not mounted on an outer wall
!
Is mounted on the wall at approx. 1,5 m from the floor
!
3.3

Connection diagrams

Connections
Utilities must be connected up to the FC Basic as shown below:
PLEASE NOTE: terminals 21-22 available on /N models.
Clean contact input or under voltage, depending on model (see label).
OUTPUT

OUT1

OUT2

3.4

Analogue inputs

There are three
index Description
ST1 NTC sensor input. room temperature (built-in, always
available)
This is the temperature control sensor. It is always
integrated on the PCB.
The selection to use the local or remote sensor is done
through
-->see
ST2 NTC sensor input. air temperature:
This is the temperature control sensor. It is always
integrated on the PCB, but can be an additional remote
sensor, positioned in the return air flow.
The selection to use the local or remote sensor is done
through
-->see
ST3 NTC sensor input water temperature:
This is the sensor used to detect water temperature and
it should always be mounted downstream of the valve.
It is involved in consent and operating functions.
This input is also used for models with
Heating/Cooling
Window contact
PLEASE NOTE: ST2 & ST3 are NOT included in the product package.
APPLICATION
2-pipe only
Heating/Cooling
analogue inputs available:
dip switch:
DIP 6 = universal models
•
• DIP 4 = specific models
dip switch table
dip switch:
• DIP 6 = universal models
DIP 4 = specific models
•
dip switch table
switch and on all other models for the
input (connection
Mounting
2-pipe with electric heater
Not used
valve Heating/Cooling
sensor range
-50C° 110C°
-50C° 110C°
-50C° 110C°
Remote
diagrams)
Electric heater
valve
meas. range
-10C° 70C°
-10C° 70C°
-10C° 70C°
FC BASIC User Manual
4-pipe
Cooling valve
Heating valve
8/24