Advertisement
SELECTING THE LOCATION
The scale should always be used in an environment that
is free from excessive air currents, corrosives, vibration
and temperature or humidity extremes. These factors will
affect displayed weight readings.
Avoid placing the scale next to or near:
• Open windows or doors.
• Air conditioning or heat vents.
• Vibrating, rotating or reciprocating equipment.
• Magnetic fields.
• Equipment that generates magnetic fields.
• Direct sunlight.
• An unstable work surface.
• A dusty environment.
REMOVING THE SHIPPING SCREW
• Remove shipping screw from bottom of scale before
using. (See Figure 1)
Figure 1
TURNING THE SCALE ON/OFF
Only power the scale on with an empty platform.
1.
Power switch is located on the left side of the scale.
Press the power switch and the scale will start to count
down from nine to zero and will display the version in
the WEIGHT display. The scale is then ready for use.
NOTE: Allow scale to warm up for at least 20
minutes before use.
2. Press the power switch again, to turn the scale off.
CHANGE UNIT OF MEASURE
1. Turn off the scale.
2. Hold down the SMPL key and turn on the scale at the
same time.
3. Enter 1-1-3-2 and press the SMPL key. The words SEtu
will be shown in the weight display and -Lb- in the
total count display.
PAGE 2 OF 6
SET-UP
INSTALLING THE PLATFORM
Place the platform on top of the scale.
LEVELING
The scale is equipped with a level indicator located to
the left of the keypad. Use the adjustable leveling feet
located on the bottom of the scale until the bubble
appears in the center circle of the indicator.
CONNECTING POWER
The scale can operate continuously by connecting
directly to AC power or operate 120 hours on a fully
charged battery.
AC ADAPTER
Plug the AC adapter into the jack on the left side of the
scale.
BATTERY
The scale is equipped with a rechargeable battery.
When the battery voltage is low, a battery symbol
will start blinking in the left display. The scale will
Shipping
automatically turn off 8 hours after the blinking has
Screw
started.
Plug the AC adapter in to recharge the battery. The
battery display window is located on the front panel on
the left side, next to the word CHARGE. When the display
is RED, the battery is being charged. It will take 8 hours
to fully charge the battery. When the display is GREEN,
the scale has been charged to its full capacity.
OPERATION
4. Press 1 to change the unit of measure. The words
SEtu will be shown in the weight display and -g- in
the total count display.
5. Press the SMPL key to accept.
6. Press the SMPL key again then press the ZERO key.
Scale will restart.
CALIBRATION
The scale is delivered pre-calibrated. There is no need
to calibrate the scale unless you feel it has become
inaccurate. You MUST use a precision test weight to
properly calibrate the scale. The test weight CANNOT
exceed the scale's capacity.
NOTE: Calibration can only be done in metric
system weight (kg).
0515 IH-1121
Advertisement
