Digital Equipment VAXstation 4000 Model 60 Upgrade Manual page 59

Installing Graphics Module (if applicable),
Install the
Graphics
Module(s)
(continued)
If you have
an... Then...
SPXgt
1.
2.
3.
4.
5.
6.
7.
8.
Install the video board clamp on the KA49
system module that was removed from the
KA46 system module.
Make sure the two slots in the metal
bracket on the graphics module line up
with the two notches on the plastic bracket
along the top rear of the system module.
Press down firmly on the module until it
secures within the two front latches of the
video board clamp.
Check to see if the front edge of the metal
bracket locks behind the ridge on the plastic
bracket.
Place the RFI gasket in between the system
enclosure and the metal bracket on the
graphics module.
Align and mate the frame buffer module
with the graphics module and the RFI
gasket. The frame buffer module tail
bracket should snap under the ridge on
the disk drive H-bracket.
Slide the E-clip back onto the frame buffer.
Install the E-clip located closest to the tail
bracket.
Continued
3–17