Digital Equipment VAXstation 4000 Model 60 Upgrade Manual page 58

Installing Graphics Module (if applicable),
Install the
Graphics
Module(s)
(continued)
3–16
SPXg
1.
2.
3.
4.
Install the video board clamp on the KA49
system module that was removed from the
KA46 system module.
Make sure the two slots in the metal
bracket on the graphics module line up
with the two notches on the plastic bracket
along the top rear of the system module.
Press down firmly on the module assembly
until it secures within the two front latches
of the video board clamp.
Check to see if the front edge of the metal
bracket locks behind the ridge on the plastic
bracket.
Continued
Continued on next page