Digital Equipment VAXstation 4000 Model 60 Upgrade Manual page 33

Removing Graphics Module (if applicable),
Remove the
Graphics
Module(s)
(continued)
If you have
an... Then...
SPXgt
1. Remove the E-clip located closest to the tail
bracket holding the SPXgt assembly together.
CAUTION Do not lift from the tail bracket. To
prevent the frame buffer from bending and
any damage occurring, gently lift by grasping
the center of the module.
2. Lift the frame buffer tail bracket just enough
to free it from the ridge on the disk drive
H-bracket.
3. Slide the top of the remaining E-clip off of the
frame buffer module, it will stay attached to
the graphics module.
4. Lift the frame buffer module and gently work
it free of the RFI gasket. Remove the frame
buffer module from the system enclosure.
5. Place the frame buffer module on the antistatic
mat.
6. Release the graphics module latches on the
video board clamp.
7. Lift the graphics module free of the system
module connector, and remove it from the
system enclosure.
NOTE The RFI gasket is now loose, remove
and place it aside for installation on the Model
90.
8. Place the graphics module on the antistatic
mat.
Continued
Continued on next page
2–17