Table of Contents
Advertisement
LAMONA Appliances
Using the hob
Do not use the ceramic hob if the glass surface is cracked, as electrical parts are directly beneath.
Switch off the appliance at the supply to prevent electric shock and contact your supplier.
The appliance is not intended to be operated by means of an external timer or separate control
system.
The hob surface remains hot after use. DO NOT TOUCH.
Controls Layout
Main Key - On/0ff
Keylock
Power / Timer Set
Cooking zone display
Cooking zone selection controls
Timer Selection
Timer Display
*During the initial startup of the hob (or power
failures) H will be displayed in the cooking zone
displays. These may not disappear until the hob
zones have been used. This is normal; the hob is
calculating surface temperatures for the hob's
residual heat indicators.
NOTE: DO NOT PLACE HOT PANS ON CONTROL
PAD AREA
08_
Turning on the hob
Touch the
key on control panel for 2-3 seconds.
Cooking zone displays illuminate.
The hob is ready for use now.
decimal points on all cooking zone displays will
flash and the timer display will show
If no operation is performed within 10
seconds, the hob will automatically return to
Standby mode.
If you press main key
seconds, the hob will turn off and return to Standby
mode.
Dot indicates feature ready to be selected or
adjusted
Residual Heat Indicators
CAUTION HOT SURFACE:
H is displayed when the surface temperature of a
cooking zone is sensed to be above 60°C.
When residual heat falls below 60°C, h appears
on the display.
symbol and all
for longer than 2
Hide quick links:
Advertisement
Table of Contents
