R82 High-low indoor Manual page 10

A B
E
2
N
C
B
1
INDOOR FRAME
WITH POWER
HIGH-LOW:X SZ. 3
The High-low:x indoor frame sz. 3 is only available with
an actuator. Use the handset (A) to adjust the height of
the seat.
Be careful when lowering this frame from the hig-
hest position to the lowest because of the risk of
finger entrapment etc.
If the the chair has to be used in the lowest position,
the foot rest has to be removed first.
The frame with power does not have a safety stop
at the height adjustment function. Please make sure
that the foot support bar does not collide with the
cross bar on the frame.
Follow the description below to recharge the batteries:
1) Plug the charging lead into the handset.
2) Plug the charger into the electricity supply and switch
on, the light on the charger will light up.
3) Charge the batteries untill the lamp on the charger
turns off.
For optimum lifetime of the actuator, connect it to
the mains voltage 12 hours before use.
To gain the optimal profit of the height ajdustment func-
tion, the batteries must be recharged every night. The
batteries can not be charged to much, but do not ever let
them drain com pletely.
The batteries are to replaced within a period of 4 years
and the new batteries must be of the same type and
manufacture.
Further, angle the adaptor by lightly pressing down the
handle (B) and pushing against the seat back.
It is important to press down on the back while the
seat is angled to ensure a slow angling.
Let go of the handle and the seat is "locked" in the wanted
posi tion.
All four wheels have brakes (C).
The height adjustment can be made both with or without
a seat on the frame.
The High-low:x indoor frame is only for indoor use.
The High-low:x frame is not approved for transpor-
tation of children in vehicles.
10