4.20
Installing the headlight mask with the headlight
4.21
Checking the headlight setting
Main work
–
Join plug-in connector
2
nectors
of the turn signals, plug-in connector
headlight and plug-in connector
E00968-10
–
Attach the brake line and wiring harness
–
Position the headlight mask and secure it with rubber
6
straps
.
The holding lugs on the headlight mask engage in the
fender.
A00196-12
Finishing work
–
Install the KTM PowerPack.
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack
installed).
–
Lock the seat.
–
Check the headlight setting.
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically a distance
wall.
400726-10
1
of the turn signal relay, plug-in con-
4
of the ignition lock.
5
.
(
p. 30)
(
p. 37)
(
p. 22)
(
p. 33)
B
under the first marking.
5 cm (2 in)
A
away from the
WORK 4
3
of the
33