4 WORK
4.5
Note
Material damage Components damaged or destroyed by water or dirt.
–
Mount the protection cap after you have removed the KTM PowerPack.
4.6
20
Removing the protection cap
F01672-10
Checking the battery discharge plug form ring
F01673-10
Main work
–
1
Remove protection cap
Finishing work
–
Install the KTM PowerPack.
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack
installed).
(
p. 37)
–
Lock the seat.
(
p. 22)
Condition
The KTM PowerPack has been removed.
The protection cap has been removed.
–
Check battery discharge plug form ring
motor.
»
If the battery discharge plug form ring is dirty:
–
Ascertain that the discharge plug is de-energized.
(
p. 37)
–
Clean the form ring without using water or compressed
air.
–
Cover the contacts and spray silicone spray onto the
form ring.
»
If the battery discharge plug form ring is damaged:
–
Change the battery discharge plug form ring.
(
p. 38)
with one hand.
(
p. 30)
1
on the electric