Advertisement
–
Route turn signal cable to the rear through the license plate
holder extension.
F01866-01
–
Make sure that the bulb is located in the socket.
»
If there is no bulb in the socket:
–
Insert the bulb included in the accessory pack in the
socket.
License plate lamp (W5W/socket W2.1x9.5d)
–
Insert the cable with the socket and bulb in the license plate
lamp.
–
Connect the plug-in connector of the left turn signal which is
F01867-10
marked red.
–
Connect the plug-in connector of the right turn signal which is
marked green.
–
Position the license plate holder extension on the license plate
bracket.
Info
Make sure the cables and plug-in connections are posi-
tioned correctly.
–
Mount and tighten screws
–
Mount the footrests with the springs and pins. Secure the pins
using the washers and cotter pins.
Footrest spring plier (58429083000)
M00695-01
–
Remove screw
Info
The screw can be reached through a drill hole in the
motor cover.
F01872-10
bt
.
ck
.
SETUP 3
15
Advertisement
