Advertisement
3 SETUP
8
–
Remove screws
–
Place handlebar supports in required position. Mount and
tighten screws
Guideline
Screw, handle-
bar support
Info
F01852-10
The handlebar supports can be mounted in four differ-
ent positions.
Position the left and right handlebar supports evenly.
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
F01842-10
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Info
The handlebar clamps and screws are in the accessory
pack.
The markings on the handlebar should be at the center
of the handlebar clamps.
Keep the installed gap widths equal when tightening.
–
Secure the handlebar cushion with two cable ties.
F01853-10
4
. Take off handlebar supports.
4
.
M10
40 Nm (29.5 lbf ft)
M8
20 Nm (14.8 lbf ft)
Loctite
®
243™
Advertisement
