Hatco FLAV-R-FRESH FDWD Series Installation And Operating Manual page 17

Humidified impulse display cabinets
Hide thumbs Also See for FLAV-R-FRESH FDWD Series:
Table of Contents

Advertisement

Available languages

Available languages

English
Self-Closing Door
an optional factory installed self-closing door is available for
FDWD-1, -1X, -2, and -2X models.
NOTE: A self-closing door cannot be reversed.
Cleaning a Self-Closing Door
The spring cover and spring needs to be removed for cleaning.
Use the following procedure to clean a self-closing door.
1. Turn off and unplug the unit. allow the unit to cool
completely.
2. Remove all pans and racks from the inside of the cabinet.
3. Drain the water reservoir completely. Refer to the
maINTENaNCE section for details.
4. Carefully lay down the unit so that the door being worked
on is facing up. If the unit must be laid on the control panel
side, take precautions to avoid damaging the fill cup and the
controls.
5. Remove the spring cover by unscrewing the cover screw.
Spring
Cover
Cover
Screw
6. Remove the spring from the long hinge pin.
a. Remove both ends of the spring from the bracket notch
and the door plate notch (use a needle nose pliers for a
better grip).
b. Slide the spring off of the pin.
Long end
of spring in
notch.
Short end
of spring in
notch.
7. Clean the spring and cover bracket.
8. Re-install the spring and spring cover.
Form No. FDWDm-0915
Spring
Cover
Cover
Screw
Spring
Bracket
Spring
Long
Notch
Hinge
Pin
Spring
Spring
Door Plate
Door Plate
Notch
Notch
OPTIONS AND ACCESSORIES
Decorative Kits
Several decorative kits are available for FDWD-1, -1X, -2, and
-2X models. Installation instructions included with kits.
FDWD-2 with Decorative Kits Installed
Top Cover Kits
FDWD-CTLh = Curved Hinge Header, Control Side
FDWD-CUSh = Curved Header, Non-Control Side
Side Inset Kits
FDWD-INSET1 = Two Crescent Inset Panels
FDWD-INSET2 = Two Wave Inset Panels
Base Skirt Kits (requires 4" [102 mm] legs, not
included)
FDWD-SQB = Flat Front, Back, and Side Panels
FDWD-1CB = Curved Front Panel, Flat Back Panel, and Flat
Side Panels
FDWD-2CB = Curved Front and Back Panels, Flat Side Panels
FDWD-CTLH
FDWD-CUSH
FDWD-
INSET1
FDWD-SQB
NOTE: Make sure to specify color when ordering.
17
FDWD-1CB
FDWD-
INSET2
FDWD-2CB
Decorative Kits

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fdwd-1xFdwd-1Fdwd-2Fdwd-2xFdwd-12-2xFdwd-12-1x ... Show all

Table of Contents