Setting The Air Temperature; Setting The Humidity Level; Food Holding Guide - Hatco FLAV-R-FRESH FDWD Series Installation And Operating Manual

English

Setting the Air Temperature

1. Press the key to enter temperature mode ("tSP" will
appear on the CaBINET TEmPERaTURE display).
2. Press the key again to show the current temperature
setting.
3. Press the key or
temperature. The temperature range is 80°–195°F
(27°–91°C) in single degree increments. See the "Food
Holding Guide" in this section for recommendations.
4. Press the key to save the setting.
5. after the desired temperature is set, wait 15 seconds
without pushing any keys for the cabinet temperature
display to return automatically to operational mode.

Setting the humidity Level

Use the following procedure to set the humidity level on
humidified units.
1. Press the key to enter humidity mode ("hSP" will
appear on the CaBINET TEmPERaTURE display).
2. Press the key again to show the current humidity level.
3. Press the key or
level. Humidity range is 0 through 5 (0 is no humidity, 1 is
the lowest amount of humidity, and 5 is the highest). See
the "Food Holding
recommendations.
4. Press the key to save the setting.
5. after the desired humidity level is set, wait 15 seconds
without pushing any keys for the CaBINET TEmPERaTURE
display to return automatically to operational mode.

Food holding Guide

Type of Food
Biscuits
Chicken Pieces (Fried)
Croissants
Fruit Pies
Onion Rings
Pizza — Thick Crust
Thin Crust
Pretzels
Wrapped Sandwiches
NOTE: All times and settings are recommendations only and may vary depending on product preparation, cooking time, and
internal food temperature.
Form No. FDWDm-0915
key to reach the desired
key to reach the desired humidity
Guide" in this section
Maximum
holding Time
4 Hours
4 Hours
4 Hours
3-1/2 Hours
1/2 to 1 Hour
1 Hour
1 Hour
3 Hours
2 Hours
NOTE: Temperature and humidity settings may vary depending
upon product make-up and consistency. The CaBINET
TEmPERaTURE display shows the lowest temperature
point inside the cabinet, not the product temperature.
The capacity of the water reservoir permits uninterrupted
operation for approximately 3–6 hours, depending on the
settings and how frequently the door is opened. When "LO
H2O" is flashing on the CaBINET TEmPERaTURE display, add
water to the reservoir. The water reservoir refill capacity is
approximately 64 ounces, or two (2) quarts (1.9 liters).
WARNING! ELECTRIC ShOCK hAzARD — Do not overfill
water reservoir.
for
humidity
Setting
4
5
1
4
1
4
5
4
4
11
OPERATION
Control Panel
Temperature
°F °C
130 55
175 80
140 60
140 60
175 80
185 85
180 82
140 60
180 82