Juniper QFX5120 Series Hardware Manual page 127

5. To remove an SFP, SFP+, XFP, or a QSFP+ transceiver:
a. By using your fingers, pull open the ejector lever on the transceiver to unlock the transceiver.
CAUTION:
lever completely until you hear it click. This prevents damage to the transceiver.
b. Grasp the transceiver ejector lever and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION:
do not touch the connector pins at the end of the transceiver.
Figure 66: Removing an SFP, SFP+, XFP, or a QSFP+ Transceiver
1 Ejector lever
—
To remove a CFP transceiver:
a. Loosen the screws on the transceiver by using your fingers.
b. Grasp the screws on the transceiver and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION:
do not touch the connector pins at the end of the transceiver.
6. By using your fingers, grasp the body of the transceiver and pull it straight out of the port.
Before removing the transceiver, make sure that you open the ejector
To prevent electrostatic discharge (ESD) damage to the transceiver,
To prevent electrostatic discharge (ESD) damage to the transceiver,
131