Removing The Controller - Parker PAC Installation Manual

INSTALLATION

Removing the Controller

To remove the PAC Controller from the DIN rail:
1. Push the module up and against the metal spring located on the underside of the rail guide.
2. Tip the module away from the rail as shown in the illustration.
3. Pull the module down and out of the mounting rail.
Adding PACIO Modules
WARNING: Always attach or remove PACIO Modules with the system in a powered-
Earth Ground
Just as with the PAC Controller, connect the PACIO Modules to Earth by attaching the metal housing to
operative Earth via the grounded DIN rail.
28 Parker Automation Controller Installation Guide
down state. Damage to the modules or unintended I/O functionality
might occur.