Mld Snooping Configuration Examples; Simulated Joining - H3C S3610 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
Note:
The reset mld-snooping group command cannot clear MLD Snooping entries derived
from static configuration.

3.8 MLD Snooping Configuration Examples

3.8.1 Simulated Joining

I. Network requirements
After the configuration, Host A and Host B, regardless of whether they have joined the
IPv6 multicast group FF1E::1, can receive IPv6 multicast data addressed to the IPv6
multicast group FF1E::1. Figure 3-3 shows the network connections.
II. Network diagram
Source
Figure 3-3 Network diagram for simulated joining configuration
III. Configuration procedure
1) Configuring a VLAN
# Create VLAN 100.
<SwitchA> system-view
[SwitchA] vlan 100
# Add Ethernet 1/0/1 through Ethernet1/0/4 into VLAN 100.
[SwitchA-vlan100] port Ethernet 1/0/1 to Ethernet 1/0/4
[SwitchA-vlan100] quit
2) Configuring simulated (*, G) joining
Ethernet1/3
Ethernet1 /0
RouterA SwitchA
IPv6 Multicast Packets
Chapter 3 MLD Snooping Configuration
Receiver
HostA
Ethernet1/2
Ethernet1/1
HostC
3-18
Receiver
HostB