H3C S3610 Series Operation Manual page 160

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
The configuration on Switch A, Switch B, Switch D, Switch E, Switch F and Switch G is
similar to the configuration on Switch C.
# Configure BSR boundary on Switch C.
[SwitchC-Vlan-interface102] pim bsr-boundary
[SwitchC-Vlan-interface102] quit
[SwitchC] interface vlan-interface 101
[SwitchC-Vlan-interface101] pim bsr-boundary
[SwitchC-Vlan-interface101] quit
The configuration on Switch D and Switch F is similar to the configuration on Switch C.
2) Configure the position of interface Loopback 0, C-BSR, and C-RP.
# Configure the position of Loopback 0, C-BSR, and C-RP on Switch C.
[SwitchC] router-id 1.1.1.1
[SwitchC] interface loopback 0
[SwitchC-LoopBack0] ip address 1.1.1.1 255.255.255.255
[SwitchC-LoopBack0] pim sm
[SwitchC-LoopBack0] quit
[SwitchC] pim
[SwitchC-pim] c-bsr loopback 0
[SwitchC-pim] c-rp loopback 0
[SwitchC-pim] quit
The configuration on Switch D and Switch F is similar to the configuration on Switch C.
3) Configuring a static RPF peer
# Configure Switch D and Switch F as static RPF peers of Switch C.
[SwitchC] ip ip-prefix list-df permit 192.168.0.0 16 greater-equal 16
less-equal 32
[SwitchC] msdp
[SwitchC-msdp] peer 192.168.3.1 connect-interface vlan-interface 102
[SwitchC-msdp] peer 192.168.1.2 connect-interface vlan-interface 101
[SwitchC-msdp] static-rpf-peer 192.168.3.1 rp-policy list-df
[SwitchC-msdp] static-rpf-peer 192.168.1.2 rp-policy list-df
[SwitchC-msdp] quit
# Configure Switch C as static RPF peer of Switch D.
[SwitchD]
less-equal 32
[SwitchD] msdp
[SwitchD-msdp] peer 192.168.3.2 connect-interface vlan-interface 102
[SwitchD-msdp] static-rpf-peer 192.168.3.2 rp-policy list-c
[SwitchD-msdp] quit
# Configure Switch C as static RPF peer of Switch F.
ip ip-prefix list-c permit 192.168.0.0
7-26
Chapter 7 MSDP Configuration
16 greater-equal 16